Makita XWT01 Manual De Instrucciones página 6

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the bit
012433
Use only the bit shown in the figure. Do not use any
other bit.
1
2
012432
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and the
bit will not be secured. In this case, try re-inserting the
bit according to the instructions above.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Ring
1
3
012434
7/16"
1. Bit
2. Sleeve
1. Bracket
2
2. Ring
3. Screws
The hook is convenient for hanging the tool with hoist.
First, place the rope through the ring. Then hang the
tool up to the air with hoist.
CAUTION:
Before using the ring, always make sure that the
bracket and ring are secured and not damaged.
Hook
CAUTION:
After installing the hook, make sure that it is screwed
firmly.
1
008150
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If
not, it may accidentally fall out of the tool, causing
injury to you or someone around you.
012430
Hold the tool firmly. Place the drill bit on the workpiece
or place the socket over the bolt or nut and turn the tool
on. For fastening operation, release the switch trigger
after the proper fastening time.
6
1. Groove
2. Screw
3. Hook
2
3