Danfoss SM Serie Manual De Instrucciones página 3

sm / sy / sz / sh / Wsh compressors
sm - sy
5
When sm compressors are used with r417A, the factory charged mineral
oil 160p must be replaced by polyolester oil 160sz.
sh
5
sz 084 - 185
sz 084 - 185
The compressor must only be used
for its designed purpose(s) and within its
scope of application (refer to «operating
limits»).
Consult Application guidelines and da-
tasheet available from cc.danfoss.com
InstructIons
A: Model number
B: Serial number
c: Refrigerant
T (°C)
0
30
T (°C)
0
T (°C)
0
t (°c)
0
Under all circumstances, the
EN378 (or other applicable local
safety regulation) requirements
must be fulfilled.
FRCC.EI.003.A6.02 © Danfoss Commercial Compressors 01/14
A
B
C
D: Supply voltage, Starting current & Maximum operating current
e: Housing service pressure
F: Factory charged lubricant
Installation and servicing of the compressor by qualified personnel only. Follow
these instructions and sound refrigeration engineering practice relating to
installation, commissioning, maintenance and service.
70
65
60
55
50
45
40
35
30
25
20
The compressor is delivered under
nitrogen gas pressure (between 0.3
and 0.7 bar) and hence cannot be
connected as is; refer to the «assem-
bly» section for further details.
sz 084 - 185
T (°C)
0
Wsh
-30 -25 -20 -15 -10 -5
T (°C)
0
sz 240, 300, 380
T (°C)
0
sz 240, 300, 380
T (°C)
0
The compressor must be
handled with caution in the
vertical position (maximum
offset from the vertical : 15°)
D
E
F
0 5 10 15 20
3