Handlebar And Stem Installation - Huffy Lil Cruzer Balance Manual De Instrucciones

Handlebar and Stem Installation

WARNING
system damage and possible loss of
control, the "MIN-IN" (minimum insertion)
mark A on the stem must be below the
top of the Locknut
NOTE:
• Remove plastic Cap
D
the Stem and discard.
• Some models have a one piece
handlebar and stem.
• If model has stem mounted Refl ector
E , make sure it is ABOVE the MIN-IN
marks, pointing forward and tightened
securely.
STEPS:
1. Insert the Stem
) making sure the MIN-IN marks
1
are below the top of the Locknut
2. Point the Stem FORWARDS and align Stem with
the front tire - Tighten the Stem Bolt
WARNING
bolt. Over tightening the stem bolt can damage the
steering system and cause loss of control.
3. If necessary, loosen the Handlebar Clamp Nut/
Bolt G and rotate Handlebar into a comfortable
riding position.
4. Tighten Handlebar Clamp Nut/Bolts
to keep Handlebar from moving during use.
Four Bolt Clamp - if equipped (view
• After adjusting for proper fi t, tighten Clamp Screws
G evenly and securely according to pattern. - Do
not over tighten.
8
: To prevent steering
B .
C
from the end of
D into the fork (view
B
: Do not over-tighten the stem
3
.
F
securely.
G securely
):
F
D
E
A
C
B
G
G
3
2
1
2
3
1
4