EN
1
DESCRIPTION
1.1
PURPOSE
This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while you mow.
1.2
OVERVIEW
Figure 1 - 12.
Handle knob
1
Lower handle
2
Upper handle
3
Knob
4
Bolt
5
Grass catcher
6
Rear discharge door
7
Mulch plug
8
Side discharge chute
9
Side discharge door
10
Height adjustment lever
11
Battery door
12
Battery pack
13
Safety key
14
Battery release button
15
Start button
16
Bail switch
17
Self-propel lever
18
Speed control button
19
Wrench
20
Mounting screw
21
Blade
22
Wood
23
Hook
24
Door rod
25
Pivot
26
Recesses
27
Mulch plug handle
28
Grass catcher handle
29
2
SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
WARNING
English
3
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until you
assemble all the parts.
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
•
If the parts are damaged, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2
UNFOLD THE LOWER HANDLE
Figure 2.
1. Pull and turn the handle knobs 90°.
2. Unfold the lower handle.
3. Line up the handle knobs in one of the three positions on
the brackets.
4. Turn the handle knobs 90° until they engage the holes in
the brackets.
Make sure that the two handle knobs are in the same
position.
Do not make damage to the cables when you fold or unfold
the handle.
3.3
INSTALL THE UPPER HANDLE
Figure 3.
1. Align the holes in the upper handle and the lower handle.
4
WARNING
WARNING
WARNING
WARNING
NOTE
WARNING