Worx WG305E Traducción De Las Instrucciones Originales página 14

SYMBOLS
WARNING
Read the manual
Wear eye protection
Wear ear protection
Wear dust mask
Double insulation.
Do not expose to rain
Remove plug from the mains
immediately if the cable is damaged
or cut.
14
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
Chain saw
All manuals and user guides at all-guides.com
OPERATION INSTRUCTION
NOTE: Before using your tool be
sure to read the instruction manual
carefully.
INTENDED USE
The chain saw is intended for sawing of trees,
tree trunks, branches, wooden beams, planks,
etc. Cuts can be sawed with or across the
grain. This product is not suitable for sawing
mineral materials.
ASSEMBLY
WARNING! Do not connect the
chain saw to mains before it is
completely assembled.
Always use gloves when handling the
chain.
CHAIN AND CHAIN BAR ASSEMBLY
1. Unpack all parts carefully.
2. Place the chain saw on a solid, level surface.
3. Use only genuine WORX chains or
those recommended for Guide Bar.
4. Slide the Chain (10) in the slot around the
Guide Bar (9). Ensure the Chain is in correct
running direction by comparing it to the
chain icon on the guide bar, or referring to
the Chain Direction Symbol (16) found on
the saw body. Ensure the Bar Tensioning
Plate (22) is facing outwards. (See Fig. A)
5. Fit the Chain onto the Drive Sprocket (15),
so that the Fastening Bar Hole (19) and the
two Bar Locating Tabs (20) on the Bar Pad
(18) fit into the keyway of the opening on
the Guide Bar (9). (See Fig. B1, B2)
6. Assure all parts are seated properly. Make
sure the drive links are fully seated in the
drive sprocket (See Fig. C1), avoiding a kink
as shown in Fig. C2. If kink occurs, pick up
on the chain at the guide bar just ahead of
the kink and then pull the kink out.
NOTE: Chain should rotate freely and be
free of kinks.
7. Fit the Chain Cover (12) and tighten
the Chain Cover by turning the Chain
Tensioning Knob (11) clockwise until it is
tight. (See Fig. D)
EN