Publicidad
D
E
FM
F
NOTE
FOR USE IN THE U.S.A.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user's right or authority to operate this product.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
All manuals and user guides at all-guides.com
AM
ENGLISH
RADIO RECEPTION → D
1 Press the POWER button to turn on the radio.
2 Set BAND to select FM or AM.
3 Turn the TUNING control to tune in to a station.
4 Adjust the volume.
To turn off the radio
Press the POWER button.
Auto power off function
The radio is automatically turned off about 90 minutes after turning on the
radio.
For better reception → E
FM: Extend the FM wire antenna fully.
AM: Turn the unit to find the position which gives the best reception.
Note
Do not connect FM wire antenna to external antenna.
ALARM SETTING → F
The radio or buzzer automatically sounds at the designated time every day.
1 Set the ALARM MODE switch to RADIO or BUZZER.
2 Turn the ALARM panel to set the alarm time.
To work the alarm timer properly,
– turn the ALARM panel counterclockwise.
– set the alarm time at least 1 hour later from the current time.
3 Set the ALARM switch to ON.
ALARM indicator changes in yellow.
When the preset time comes, the radio or buzzer sounds. If you select
BUZZER in step 1, buzzer and radio sounds at the same time.
To turn off the alarm, set the ALARM switch to OFF or press the SNOOZE
button.
When the SNOOZE button is pressed, the buzzer or radio automatically
comes on again after about 5 minutes.
Note
• The radio or buzzer automatically turns off after about 30 minutes.
• To cancel the alarm before the preset time comes, set the ALARM switch
to OFF.
SPECIFICATIONS
Power source
DC 4.5 V using three size AA (R6) batteries
Output
160 mW (EIAJ)
Speaker
50 mm, 8 ohms
Frequency range
FM: 87.5 – 108 MHz
AM: 530 – 1,710 kHz
Antennas
FM wire antenna
Ferrite bar antenna for AM
Battery life (EIAJ 10 mW)
Using manganese batteries (R6P)
Approx. 34 hours for AM reception
Approx. 30 hours for FM reception
Using alkaline batteries (LR6)
Approx. 68 hours for AM reception
Approx. 60 hours for FM reception
Maximum outside dimensions (W × H × D)
102 × 161 × 89 mm
Weight
Approx. 360 g (excluding batteries)
• The specifications and external appearance are subject to change without
notice.
Publicidad
