Operating Instructions; Assembly & Operation; Before Operation - Walmart Hyper Touch HT19-401-003-15 Manual Del Usuario

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for cleaning and watering.
ASSEMBLY & OPERATION

BEFORE OPERATION

Installing the battery pack
NOTE: Before operation, make sure the battery is locked into position securely and the battery
protection cover is fully closed.
Removing the battery pack
Open the battery protection cover and press and battery pack release button repeatedly to get out the battery.
Charging the battery pack
More details can be found in the section "For battery charger".
ASSEMBLY
Attaching extension lance to the power nozzle
NOTE: When attaching, align the two projections on the lance with the grooves of the power nozzle as
shown in Fig. B.
Attaching the multi-spray nozzle
NOTE: When attaching, gently pulling the nozzle to make sure it is locked into position securely.
Attaching the hose to the power nozzle
NOTE: After the draw hose is attached, check the connection by gently pulling upon the draw hose. It
should not be pulled off.
Attaching your own water hose (optional)
1. Attach the quick connect adapter
2. Attach your household garden hose with suitable connectors
NOTE: Except for the draw hose supplied, you can also connect the power nozzle to your own water
hose with suitable connectors.
NOTE: Check whether the filter screen is missing before retightening the hose adapter. (Fig. E1, E2)
When retightening the hose adapter, please tighten securely. Otherwise, it may not draw any water for
proper operation.
WARNING: It is not recommended to connect the draw hose to your garden hose or your
home tap.
OPERATION
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle pattern according to your work. Spray
patterns 0 , 15 , 25 and 40
o o o
pattern with the symbol
WARNING: Do not shift the nozzle pattern when the tool is powered on due to potential water
leakage.
Make sure the nozzle pattern symbol aligns with the indicator mark on tool, otherwise the nozzle will
leak and there will be no sufficient pressure.
Start
NOTE: At the first use, you need to empty the air in hose, place the
power nozzle below waist level (<5ft/1.5m), then attach the pressure cleaning lance and set it at high
pressure. It does not start working until the water goes up along the hose and sprays out. This could
take up to 30 seconds or more depending on the fresh water source.
Watering
NOTE: It is recommended to use the low pressure mode for watering.
Cleaning
WARNING:Do not connect the machine to water supplies that are dirty, rusty, muddy, or
corrosive. (Including window cleaning liquids, plant foods, or fertilizers etc.)
NOTE: Not recommended for use with salt water, immediately rinse with fresh water for proper maintenance.
All manuals and user guides at all-guides.com

OPERATING INSTRUCTIONS

ACTION
are applicable for cleaning, and the spray
o
is best suitable for showering.
8
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3, A4, A5
See Fig. B
See Fig. C
See Fig. D1, D2
See Fig. E1, E2, E3
See Fig. F1, F2
See Fig. G
See Fig. H
See Fig. I, J