General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PMS 160 B2 Manual Del Usuario

NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with
a standardised test procedure and can be
used for comparison of the power tool with
another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece being worked, the
vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool .
► Try to keep the vibration load as low as
possible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the power
tool is switched on but running without load) .
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illus­
trations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .
PMS 160 B2

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .

2 . Electrical safety

a) Power tool plugs must match the outlet.
Never modify the plug in any way. Do not use
any adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock .
b) Avoid body contact with earthed or
grounded surfaces, such as pipes, radiators,
ranges and refrigerators. There is an
increased risk of electric shock if your body is
earthed or grounded .
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock .
d) Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entan-
gled cords increase the risk of electric shock .
e) When working outdoors with an electrical
power tool always use extension cords that
are also suitable for use outdoors. Use of a
cord suitable for outdoor use reduces the risk
of electric shock .
f) If operating a power tool in a damp location
is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD
re duces the risk of electric shock .
GB │ MT │ 39 ■