Reducer; Operation; Switching On And Off; Working Procedures - Parkside PMS 160 B2 Manual Del Usuario

NOTE
► To ensure optimum dust extraction, empty the
dust box 3 regularly .
♦ To do this, remove the dust box 3 from the
appliance as described above . Open the dust
box 3 by pressing the release button 2 and
pulling off the rear part . Now remove the dust
bag 4 (see detailed illustration on fold-out
page) . Clean the dust bag 4 thoroughly by
tapping it out .

Reducer

Connecting
♦ Push the reducer 5 into the adapter connec-
tion 6 .
♦ Push the hose of a suitable vacuum cleaning
appliance (e .g . a workshop vacuum cleaner)
onto the reducer 5 .
Removal
♦ Pull the hose of the vacuum cleaner off the
reducer 5 .
♦ Pull off the reducer 5 .

Operation

CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains .
NOTE
► Always switch the multi-sander on before
applying it to the material, then move it over
the workpiece .
PMS 160 B2

Switching on and off

Switching on the appliance
♦ Move the ON/OFF switch 1 to the "I"
position .
Switching off the appliance
♦ Move the ON/OFF switch 1 to the "0"
position .

Working procedures

■ Switch the appliance on before applying it to
the workpiece .
■ Apply minimal pressure when working .
■ Work at a constant speed .
■ Change the sanding sheets regularly .
■ Never use the same sanding sheet for sanding
different materials (e .g . wood followed by
metal) . Optimum sanding results can only be
achieved by using clean sanding sheets .
■ Clean the sanding sheet every once in a while
using a vacuum cleaner .
■ Sand hard-to-reach places with the front or side
edge of the sanding sheet on the sanding plate .
■ Guide the sander over the workpiece in parallel
and use overlapping sanding motions .
■ After completing the task, lift the appliance from
the workpiece and then switch it off .
GB │ MT │ 43 ■