Installing Adapter Brackets - SlimLine SLFMU Manual Del Usuario

Installing Adapter Brackets

2
7R SUHYHQW VFUDWFKLQJ WKH VFUHHQ VHW D FORWK RQ D ÀDW OHYHO VXUIDFH WKDW ZLOO VXSSRUW WKH ZHLJKW RI
the screen. Place screen face side down. If screen has knobs on the back, remove them to allow the
adapter brackets to be attached. Place adapter brackets (B) on back of screen, align to holes, and
center on back of screen as shown below. Attach the adapter brackets to the back of the screen using
the appropriate combination of screws, washers, and spacers as shown in steps 2-1 or 2-2.
NOTE: Top and bottom holes of screen must always be used.
Verify that all holes are properly aligned, and then tighten screws using allen wrench (L).
X
B
CENTER BRACKETS
VERTICALLY
ON BACK OF
SCREEN
X
NOTE: "X" dimensions should be equal.
NOTE: For ÀDW EDFN VFUHHQV proceed to step 2-1. For bump-out or recessed back screen skip to
step 2-2.
6 of 44
ISSUED: 12-02-09 SHEET #: 202-9418-1