Tescoma President 909050 Instrucciones De Uso página 8

Gradually adding food in the pulse mode
Release "Pulse" during the pulse blending mode and wait until the blending stops. Remove the closure of the filling hole from
the lid by slightly rotating it and add liquids and cut food into the jar through the hole. Set the closure of the filling hole back on
and continue pulse blending.
Measuring container with spout
Use the measuring container with spout for accurately measuring out food and other ingredients and easily adding them
through the filling hole in the lid.
Tamper
(17)
If, during operation in a programme or in manual use, a layer of food is formed in the jar that remains unblended, use the tamper.
Do not stop the soup maker, remove the closure from the lid, insert the tamper into the filling hole and press the unblended
food down.
Important notice
Do not leave the soup maker to blend for more than 6 minutes at a time! If the appliance stops due to overheating during the
blending process, disconnect it from the grid, do not use it for 20 minutes, then connect again and continue blending. If the
blades get stuck while blending, disconnect the power cord from the grid, lift the jar, remove the food which caused the blades
to stop and continue using the appliance after the motor cools down.
Quick cleaning
For quickly cleaning any pulp etc. stuck inside the glass jar and the cutting blades, fill the jar with clean water with a few drops
of detergent up to about one half of the volume. Set the lid with closure onto the jar and repeatedly press and release "Pulse".
Then pour out the water with detergent and thoroughly rinse the jar.
Cleaning
(18)
Disconnect the soup maker from the grid and disassemble before cleaning. Lift the glass jar from the base, slightly rotate the lid,
remove it from the jar and remove the closure from the filling hole.
Glass jar
Clean the inside of the glass jar and the cutting edges of the cutting blades using the enclosed brush. Thoroughly rinse the
cleaned jar and leave it to dry; clean the outside of the jar with a moistened cloth, rinse under running water if needed and dry;
do not wash in dishwasher. Notice: As the stainless steel blades are firmly attached to the bottom of the jar, they cannot be removed;
be very careful in cleaning – the cutting edges of the blades are extra sharp!
Base of the soup maker
If necessary, wipe the base of the soup maker with a dry or dampened cloth. Do not wash under running water or in dishwasher.
Notice: Make sure when washing the glass jar and the base that water does not enter the connectors. If this happens, remove the
water and leave the connectors to dry completely before use.
Lid, lid closure, tamper and brush
Clean under running water and leave to dry. Do not wash in dishwasher.
Maintenance
If the rubber insert of the shaft drive becomes worn or damaged from intense use, remove it using a suitable object and put into
its place the replacement rubber insert which comes with the product's accessories. Do not repair a faulty appliance yourself; in
case of any failure contact a TESCOMA retail centre or service centre; for contact details, see www.tescoma.com.
Notice
Soup maker with blender PRESIDENT 1.75 l comes with specially shaped and ground cutting blades made of high-grade
stainless steel. Intense or inappropriate use (food that is too hard or too large) inherently causes the blades to become dull,
which cannot be claimed.
8