Fastening The Inverter To A Flat Surface; Connecting Inverter Cables; Important - Schumacher Electric PI-200 Manual Del Propietário

If a device does not operate properly when first con-
nected to the inverter, turn the inverter rocker switch ON
(I), OFF (O), and ON (I) again in quick succession. If this
procedure is not successful, it is likely that the inverter
does not have the required capacity to operate the de-
vice in question.
4. fASTENING THE INVERTER TO A fLAT
SURfACE
For convenience your inverter can be fastened to a flat
surface, horizontally or vertically. The area where the
inverter is to be fastened must be dry, well ventilated and
away from any combustible material or fumes.
1. Turn off and disconnect the inverter.
2. Place the back of the inverter with the mounting
bracket against a secure and flat surface.
3. Attach the inverter to the flat surface using corro-
sion resistant screws.
5.

CONNECTING INVERTER CAbLES

The inverter and power source must be in the OFF
mode.
IMPORTANT: Make sure you connect your inverter to a
12-volt power supply only.
INVERTER CONNECTION (Models PI-400 and PI-
750):
NOTE: For model PI-400, determine whether you will be
using the battery clamps (400 watt output maximum) or
the 12V accessory plug (120 watts maximum).
All manuals and user guides at all-guides.com
• 8 •