Publicidad
Idiomas disponibles
Idiomas disponibles
ICSS300 P.book Seite 13 Donnerstag, 6. Dezember 2007 10:06 10
Connecting the burner/device
Connect cable 12 at the burner 9 and plug cable
into black connection jack 3.
Plug ground/earth connection cable 13 into red
ground/earth
connection
ground/earth clamp 14 to workpiece. Ensure prop-
er contact.
Insert plug of mains cable 1 into socket outlet.
Mounting/dismounting a scraper
Loosen screw 21 with Allen key 15 (figure
Cleaning kit (figure
)
B
– Insert stainless steel scraper 20 into the opening
on the burner 9 and tighten screw 21 again.
– Insert plastic tube 17 into the opening on the
burner 9.
Polishing kit (figure
)
E
– Insert graphite scraper 22 into the opening on the
burner 9 and pay attention that the plastic
tube 17 engages into the corresponding hole.
– Tighten screw 21.
Mounting the cleaning/polishing pad
Cleaning pad (figure
)
B
– Loosen screw 21 somewhat.
– Insert retaining spring 19 between scraper 20
and housing.
– Secure scraper 20 and retaining spring 19 by
tightening screw 21.
– Lightly bend retaining spring 19 and attach the
matching cleaning pad 16 to the scraper 20.
Polishing pad (figures
,
F
– Insert the matching Teflon ring into the holder of
the stand.
– Place polishing pad 24 flat onto the Teflon
ring 23.
– Press the edge of the scraper through the centre
of the ring, so that the polishing pad 24 is folded
over the scraper 22.
Filling-in cleaning/polishing agent
– Unscrew lid from tube 10/ 25 and pull off the
protective foil.
– Attach tube 10/ 25 to burner 9 and tighten.
jack 4,
and
fasten
).
A
,
)
G
H
Working Instructions
Cleaning/polishing welding seams
(figures
,
)
C
D
Set to the CLEANING or POLISHING mode with the
mode selector switch 5.
Press pushbutton 18 several seconds until the fluid
flows into the pad 16/ 24.
After each actuation, wait for approx. 2 –3 seconds
until pressing pushbutton 18 again. This ensures
that the pump system operates properly.
When starting the device for the first time, this proc-
ess must be repeated approx. 4 –5 times.
Place cleaning/polishing pad onto the welding spot
and move it back and forth applying firm pressure.
Repeat the procedure until the welding seam is
cleaned/polished. After the working procedure, in-
sert burner 9 into holder 11.
To avoid/remove remainders or scales/crusts, clean
the cleaned/polished location afterwards with a
moist cloth or sponge.
Never use the burner without a pad.
The pad must always be completely soaked with
fluid, otherwise, the service life will be heavily
reduced.
Marking Set
(Accessory - Figure
Connecting the marking pen
Connect cable 12 to handle 28 and plug cable into
black connection jack 3.
Plug ground/earth connection cable 13 into red
ground/earth
connection
ground/earth clamp 14 to workpiece.
Mounting the marking tool
– Loosen screw 32 at the handle.
– Insert graphite scraper 31 into the opening on the
handle 28 and tighten screw 32 again.
– Place marking felt 29 onto graphite scraper and
secure with ring seal, round 30.
)
I
jack 4,
and
fasten
13
Publicidad
