Outer Cleaning - EPTA IARP GLEE X-SLIM NV Manual Del Usuario

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante

17. OUTER CLEANING

WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
1. EXTERNAL BODY:
When necessary, the external body should be cleaned with a cloth and a neutral soap and water solution.
2. STAINLESS STEEL SURFACES:
pads etc. which will spoil the finish of the stainless steel.
3. SURFACES IN PLASTIC MATERIAL:
no circumstances should alcohol, methylated spirits or solvents be used.
4. GLASS SURFACES:
can leave a film of calcium on the surface of the glass.
18. INNER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
If , however, the layer of frost on tank walls exceeds 4/5 mm in thickness, you should completely defreeze the appliance as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature
2. Leave the doors open and begin the operation of tank washing when the tank temperature is the same as the ambient temperature.
3. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
4. Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
5. Avoid water entering into the appliance lighting units.
6. Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Non usare getti d' acqua nelle operazioni di pulizia: si possono danneggiare le parti elettriche.
Non usare dispositivi meccanici o altri mezzi per accelerare il processo di sbrinamento, diversi
da quelli raccomandati dal costruttore.
19. MAINTENANCE
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention
on the flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
OPERATION
Cleaning of external surfaces
Cleaning of accessible internal parts (no use of tools)
Seals intactness check
Water collection tank cleaning
Checking and cleaning the condenser if necessary
Replacement components and parts
* Recommended frequency for optimal counter operation and maintenance of full efficiency.
Any other maintenance operation not planned in the previous points should be carried out by the
support centres authorised by our dealers or by qualified staff.
GLEE X-SLIM NV
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
Wash with warm water and mild detergent, rinse well and dry with soft cloth. Avoid scouring
Wash with warm water and mild detergent, rinse well and dry with soft cloth; under
Only use products specifically designed for glass cleaning; It is not advisable to use ordinary water which
FREQUENCY MAINTENANCE
Based on use Ordinary
Based on use Ordinary
Yearly * Ordinary
Yearly * Ordinary
Yearly * Ordinary
- Extraordinary
1 9 / 5 6
PAGE
UM000543
N° DOC
AUTHORISED STAFF
User
User
Technical support
Technical support
Technical support
Technical support