Publicidad
Idiomas disponibles
Idiomas disponibles
For non-BOSE systems:
• Disregard the White RCA, it will not be used in this application.
• Disregard the Gray RCA, it will not be used in this application.
• Connect the Green RCA to the left rear RCA output.
• Connect the Purple RCA to the right rear RCA output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
Tape off and disregard the following wires, they will not be used in
this application:
• The Green, Green/Black, Purple, Purple/Black wires.
For BOSE systems:
• Connect the White RCA to the left front RCA output.
• Connect the Gray RCA to the right front RCA output
• Connect the Green RCA to the left rear RCA output.
• Connect the Purple RCA to the right rear RCA output
Tape off and disregard the following wires, they will not be used in
this application:
• The Green, Green/Black, Purple, Purple/Black, White, White/Black,
Gray, and Gray/Black wires.
Note: It is highly recommended that the radio being used has 2 sets
of RCA outputs to retain balance and fade; 3 sets if a sub-woofer amplifier
will be added.
(c)
From the 12-pin harness (ASWC-1 pre-wired harness):
• This harness is to be used in conjunction with the optional ASWC-1 (not
included) to retain steering wheel controls. If the ASWC-1 is not being
used, disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
METRA. The World's best kits.
AX-ADXSVI-AU1
1-800-221-0932
™
Installing the AX-ADXSVI-AU1
• Connect the 12-pin harness into the AX-ADXSVI interface (sold separately).
• Connect the 40-pin harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, then back on again.
Troubleshooting
• If the vehicle has engine noise after installing the AX-ADXSVI-AU1, use Axxess
part number AX-AGL610, qty. (2).
IMPORTANT WARNING
This product includes instructions for installation which must be carefully followed. The
instructions are worded in such a manner to assume that the installer is capable of
completing these type of electronic installations. If you are unclear as to what you are
instructed to do or believe that you do not understand the instructions so as to properly
and safely complete the installation you should consult a technician who does have this
knowledge and understanding.
Failure to follow these instructions carefully and to install the interface as described
could cause harm to the vehicle or to safety systems on the vehicle. Interference with
certain safety systems could cause harm to persons as well. If you have any questions
in this regard please call the Help line or Metra at 1-800-221-0932 for assistance.
K
P
NOWLEDGE IS
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
metraonline.com
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians
Publicidad
