Description Of Controls - Bras ATLAS L Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN GLIS H
A T L A S L
located on its lower part. (see figure 2)
10
To release a locked top cover it is necessary to insert a
sharpened object in the hole located in the middle of the fixing
button, push it and lift the cover. (see figure 3)

7. 1 DESCRIPTION OF CONTROLS

The dispenser is equipped with a power switch and a light
switch. In addition each bowl is individually operated by a mixer/
refrigeration switch. In fact it is possible to dispense both soft
drinks and Granita.
When a bowl is in Soft Drink mode the beverage temperature is
controlled by the corresponding thermostat.
When a bowl is in Granita mode the mix viscosity is controlled
by the corresponding adjustment screw located in the rear wall
of each container (for temperature and viscosity setting make
reference to chapter 7.2 OPERATION HELPFUL HINTS).
All the switches are located on the faucet side of the dispenser
figure 2
figure 3
in switch panels protected by switch covers (see figure 4).
In addition all the models except MT 1 are equipped with an
automatic safety pressure switch to prevent damages to the
compressor. The lighting of the warning light at the left of the
switch covers means insufficient ventilation of the unit. In this
case check that all around the dispenser there is sufficient
space for ventilation, at least 15 cm (6") on each side and that
condenser filter is free from dust or other obstructions.
In case the warning light is still ON even after these operations
have been carried out, Service call is required.
With reference to figure 5 dispenser controls functions are as
follows:
Power switch (A)
0 position
:
power is turned OFF to all functions.
I position
:
power is turned ON to all functions and the
other switches are enabled. The fan motor
runs.
Light switch (E)
0 position
:
all top cover lights are OFF.
I position
:
all top cover lights are ON, provided that
power switch (A) is set to I.
Mixer/refrigeration switch (B)
I position
:
mixer and refrigeration ON.
SOFT DRINK mode.
0 position
:
OFF.
II position
:
mixer and refrigeration ON.
GRANITA mode.
Thermostat (D)
Turn clockwise
Turn counterclockwise
To operate the unit:
1
Set the power switch to I position.
2
Set the mixer/refrigeration switches as follows:
- to the I position to get soft drink.
- to the II position to get Granita.
14
figure 4
figure 5
: to decrease temperature
: to increase temperature

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Atlas 2

Tabla de contenido