Height Adjustment; Inclination Adjustment - Maggi STEFF 2032 Manual De Usuario

CHAPTER 3 - USE AND ADJUSTMENTS
WARNING
All adjustments must be made
while the machine is disconnected
from the mains by unplugging.

3-1 HEIGHT ADJUSTMENT

To adjust the power feeder for height,
it is necessary to take account of the
thickness of the piece to be cut (see
Fig.11). Place the wheels at a height
approximately 3-5 mm less than the
height of feeding plane, so that they
hold firmly at all times; the suspension
system will offset any
differences.

3-2 INCLINATION ADJUSTMENT

The power feeder has been designed
to be used on several machines. In
any case, to make sure that the piece
movement is parallel to the guide-
square, it is necessary to place the
power feeder at a slight angle to the
direction of the piece motion (see
Fig.12).
For applications in which the feeder is
used in "vertical position", therefore,
make sure the distance (B) between
height the outlet roll and the square is 5-6
mm less than that of the inlet roll (A).
A = B +5/6 mm
Fig.12
Fig.11
For applications in which the power
feeder is used in
position" (Fig.13), make sure the
distance (B) between the outlet roll
and the plane of the machine is 5-6
mm less than the distance (A), which
is the distance between the inlet roll
and the plane of the machine tool.
Fig.13
A = B +5/6 mm
EN
"horizontal
41