Publicidad
Step 11
Carefully turn your unit over onto its front edges. Lay the
å
BACK (H) over your unit.
Make equal margins along the top and side edges of the
å
BACK (H). Push on opposite corners of your unit if needed
to make it "square".
Fasten the BACK (H) to your unit using the NAILS (5N).
å
Fasten an ANGLE BRACKET (27G) to the RIGHT END
å
(A2) and MOLDING (W). Use two BLACK 9/16" LARGE
HEAD SCREWS (1S).
NOTE: There is no pre-drilled hole in the MOLDING. The
å
SCREW will tighten into the groove.
27G
BLACK 9/16" LARGE HEAD SCREW
(2 used for the ANGLE BRACKET)
Page 16
A2
W
1S
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the BOTTOM (E).
H
401685
5N
NAIL
(18 used in this step)
www.sauder.com/services
Publicidad
