Assembling Instructions; Install Lower Bar; Install Curved Handle; Installing The Grass Box - Grizzly Tools ARM 2033-22 Traducción Del Manual De Instrucciones Original

All manuals and user guides at all-guides.com
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool gener-
ates an electromagnetic
field which, under certain
circumstances, may impair
the functionality of active or
passive medical implants.
To reduce the risk of serious
or lethal injuries, we rec-
ommend that persons with
medical implants consult
their doctor and the manu-
facturer of their medical
implant before operating the
machine.

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confident.
• In case of uncertainty, contact a spe-
cialist or contact our service directly

Install lower bar

1. Open the lower bar (4) and move it to
the desired inclination.
2. Fix the lower bar by means of the pre-
mounted quick-release levers (5).

Install curved handle

1. Fasten the bow-type handle (1) with
the screws and the upper quick-re-
lease levers (2) to the right and left of
the lower bar (4)..
2. Clipping in the cable holders: Clip the
cable holders (
bar to fixate the machine cable
( 16).
If you loosen the quick release le-
vers, you can fold down the curved
handle and the lower part of the
handle for storage of the device.

Installing the grass box

The collection box is already completely
preassembled.
1. Loosen the Phillips screw (19a) on the
carrying handle (19).
2. Place the carrying handle (19) on
the upper side of the grass collection
box (13) and screw it tight with a Phil-
lips screw (19) from below.
3. Place the plastic tabs (13a) over the
grass collection box rods (13b).
Attention: Do not operate the ap-
pliance until the collision guard
and grass box are fully installed.
Risk of injury!

Insert/remove battery

Switch off the device, remove the
safety key (
blade to come to a stop. There is a
risk of personal injury.
1. To insert the battery (7) into the de-
vice, push the battery along the guide
rail into the device. It locks into place
audibly.
2. To remove the battery (7) from the de-
vice, press the release button (
on the battery and pull the battery out.
GB
15) onto the lower
20) and wait for the
7b)
27