Safety Instructions For Assembly; Electrical Safety - FALMEC Domino 38 Manual De Instrucciones

- Reduction of the power level set.
- Shutdown of the cooking area concerned.
On the display of the cooking area the message "E2"
is displayed.
It is possible to restore the cooking area when the de-
fault message is off.
SAFETY INSTRUCTIONS
FOR ASSEMBLY
Install the cooker after installing kitchen cabinets and
basis.
Make sure that worktops have been veneered with
thermoresistant glue in order not to suffer deflections
or detachments.
It is forbidden to install the appliance on fridges or
freezers, washing machines, dishwashers, or tumble
driers.

ELECTRICAL SAFETY

The electrical system to which the cooker is
to be connected must be in accordance
with local standards and supplied with
earthed connection in compliance with safety
regulations in the country of use. It must also
comply with European standards regarding radio
antistatic properties.
Make sure that it can't be possible to touch the power
cable of the cooker after it has been built-in and that
it is not subject to mechanical stress.
The socket used to connect the installed equipment
to the electrical power supply must be within reach:
otherwise, install a mains switch to disconnect the
hood when required.
Any changes to the electrical system must be carried
out by a qualified electrician.
Do not try to solve the problem yourself in the event
of equipment malfunction, but contact the Dealer or
an authorised Servicing Department for repairs.
When installing the cooker, disconnect
the equipment by removing the plug or
switching off the main switch.
ELECTRICAL CONNECTION
(only intended for qualified personnel)
Disconnect the equipment from mains power network before carry-
ing out any operation on the cooker.
Make sure that electric wires inside the cooker are not disconnected
or cut:
in the event of damage, contact your nearest Servicing Department.
Refer to qualified personnel for electrical connections.
Connection must be carried out in compliance with the provisions of law
in force.
Before connecting the cooker to the mains power network, check that:
• the mains voltage corresponds with the voltage indicated on the data plate
located inside the cooker;
• the electrical system is compliant and can withstand the load (see the techni-
cal specifications located inside the cooker);
• the power supply plug and cable do not come into contact with tempera-
tures exceeding 70 °C;
• the power supply system is effectively and properly connected to earth in
compliance with regulations in force.
• the socket used to connect the cooker is within reach.
In case of:
• devices fitted with cables without a plug: the type of plug to use is a ''stand-
ardised'' one. The wires must be connected as follows: yellow-green for earth-
ing, blue for neutral and brown for the phase. The plug must be connected to
an adequate safety socket.
• fixed equipment not provided with a power supply cable and plug, or any
other device that ensures disconnection from the electrical mains, with an
opening gap of the contacts that enables total disconnection in overvoltage
category III conditions.
Said disconnection devices must be provided in the mains power supply in
compliance with installation regulations.
The yellow/green earth cable must not be cut off by the switch.
The Manufacturer declines all responsibility for failure to comply with the safety
regulations.
Connection of the cooker:
network Connection
230V~ Single-phase
50/60Hz + N
* calculated with the contemporary factor in compliance with EN 60 335-2-6.
POWER:
Feature
Total power
Front position
Rated power
Booster power
Back position
Rated power
Booster power (1/2)
15
Cable section Power cable Switch
gauge
3 x 2.5 mm² H 05 VV - F 25 A *
H 05 RR - F
38 38 Plus
3500W 3500W
1600W 2100W
1850W 3500W
2100W 2100W
2100/3000W 3500W