Installing The Battery; Assembly & Set-Up - Black and Decker Crossfire BDL310S Manual De Instrucciones

587012-00 BDL310S laser
3

Installing the Battery

Ensure laser on/off switch is in the left
"OFF" position. Remove the battery
compartment cover by pressing the tab of
the cover in towards the center of the laser
and out as shown in figure 4. A rubber
plug is located inside the compartment.
The plug is used to protect the laser from
transportation damage.
Remove the plug by rotating it 90° and
pulling it straight out.
Connect a fresh 9 volt alkaline battery
making sure to match (+) and (-) terminals
correctly. Replace the battery
compartment cover.
Note: When transporting the laser or storing
it for extended periods of time, remove the
battery and replace the rubber plug.
WARNING: Choking hazard. Store
rubber plug out of the reach of
children.
WARNING: Batteries can explode, or
leak, and can cause injury or fire. To
reduce this risk:
• Carefully follow all instructions and warnings
on the battery label and package.
• Always insert battery correctly with regard
to polarity (+ and -), marked on
the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Remove dead battery immediately and
dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove battery if the device will not be
used for several months.
4
Rubber Plug
5/26/04 10:28 AM Page 3
Assembly / Set-up
Vertical Mounting
The wall / tabletop mounting bracket uses
push pins or a screw hole to secure it to a
vertical surface.
CAUTION: Pins are sharp and should
be handled with care. NOTE: The pins
are only for use when hanging the bracket
on drywall, NOT other surfaces including
plaster. For surfaces other than drywall,
the key hole can be used with a standard
screw or nail in a predrilled hole.
The pins stay retracted until you are ready
to mount the bracket. To release the pins,
twist the black knobs shown in figure 5
clockwise until they stop.
5
Position the bracket on a vertical surface.
Hold the bracket as shown in figure 6,
keeping your fingers on the front, and
push in with even pressure on both knobs.
Make sure it is seated firmly and that the
unit is secure on the wall.
IMPORTANT: When attaching or
removing the bracket, be sure to push in
or pull out with even pressure on both
push pins.
6
3
Pins retracted
in this position
Keyhole
Pins released
in this position
Push in with even
force on both pins.