Troubleshooting - Black and Decker MATRIX BDCMTHD Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

SCREw DRIVING

For driving fasteners, the reversing button should be pushed to the left. Use reverse (button

pushed to the right) for removing fasteners. When moving from forward to reverse, or vice

versa, always release the trigger switch first.

DRILLING

• Use sharp drill bits only.

• Support and secure work properly, as instructed in the Safety Instructions.

• Use appropriate and required safety equipment, as instructed in the Safety Instructions.

• Secure and maintain work area, as instructed in the Safety Instructions.

• Run the drill very slowly, using light pressure, until the hole is started enough to keep the drill bit

from slipping out of it.

• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not

so much as to stall the motor or deflect the bit.

• Hold the drill firmly with two hands, one hand on the handle, and the other

gripping the bottom around the battery area.

• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT TO

START IT. DAMAGE TO THE DRILL CAN RESULT.

• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part

of the hole.

• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.

• Make sure switch turns drill on and off.

DRILLING IN wOOD

Holes in wood can be made with the same twist drill bits used for metal or with spade bits. These

bits should be sharp and should be pulled out frequently when drilling to clear chips from the flutes.

DRILLING IN METAL

Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which should

be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.

DRILLING IN MASONRy

Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill but not so

much that you crack the brittle material. A smooth, even flow of dust indicates the proper drilling rate.

Problem

• Unit will not start.

For assistance with your product, visit our website www.blackanddecker.com for the location

of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.

NOTE: Refer to Power Unit instruction manual for troubleshooting solutions regarding opera-

tion of the Power Unit.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;

never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual) should be performed by authorized service

centers or other qualified service personnel, always using identical replacement parts.

ACCESSORIES

wARNING

The use of any accessory not recommended for use with this tool could be hazardous.

Recommended accessories for use with your tool are available from your local dealer or authorized

service center. If you need assistance regarding accessories, please call: 1-800-544-6986.