Tabla de contenido
Publicidad
A
SPEAKER
A
B
10
B
SUBWOOFER
Connections 1
CAUTION
< Turn off the power of all the equipment before
making connections.
< Read instructions of each component you intend
to use with this unit.
< Be sure to insert each plug securely. To prevent
hum and noise, do not bundle the connection
cords with the power cord or speaker cord.
A
Speaker Connections
Caution:
< To avoid damaging the speakers by inputting a
sudden high-level signal, be sure to switch the
power off before connecting the speakers.
< Check the impedance of your speakers. Connect
speaker with an impedance of 6 ohms or more.
< The amplifier's red speaker terminals are the +
(positive) terminals and the black terminals are the
_ (negative) terminals.
The + side of the speaker cable is marked to
make it distinguishable from the negative side of
the cable. Connect this marked side to the red +
terminal and the unmarked side to the black _
terminal.
< Prepare the speaker cords for connection by
stripping off approximately 10 mm or less (no
more as this could cause a short-circuit) of the
outer insulation. Twist the wires tightly together
A
to avoid tangles:
How to connect
1. Turn the terminal cap counterclockwise to loosen
it. The speaker terminal caps cannot be fully
removed from the base.
2. Insert the wire into the terminal fully and turn the
terminal cap clockwise to securely connect it:
3. Make sure it is fastened firm by pulling the cable
lightly.
B
SUBWOOFER OUT jack
Connect a commercially available powered
subwoofer.
< Subwoofer output will not be cut off, when the
headphone jack is inserted.
ENGLISH
B
Publicidad
Tabla de contenido
