Transport And Storage - Koenic KVC 3121 A Manual De Instrucciones

English
Assembling the vacuum cleaner (Part B, C, N)
Fig. Insert the suction hose into the hose
1
connection. Make sure that it has clicked
into place.
Place the floor nozzle on the lower end
Fig.
2
and the suction tube handle on the
upper end of the telescopic tube.
Fig. Adjust the telescopic tube to the
3
desired length, by sliding up the locking
mechanism and then pushing the
telescopic tube out or squeezing it
together.
Use of the accessories provided
Floor nozzle (Part H)
Fig. To vacuum hard floors, press the toggle
4
switch down.
Fig. To vacuum carpeted areas, press the
5
toggle switch again in order to retract
the brushes.
Upholstery nozzle round/square (Part K, M)
Fig. For vacuuming upholstered furniture,
6
mattresses, cushions, curtains, etc.
Crevice nozzle (Part J)
Fig. For vacuuming folds, crevices and corners.
7
Hard floor brush (Part L)
For vacuuming hard and wooden floor.
Fig.
8
Use the hard floor brush to protect the
floor from being scratched.
16
IM_ KVC3121A_160426_V02_HR.indb 16
Operation
Fig. Pull out the connection cable to the
9
desired length and insert the power plug
into a receptacle.
Press the On/Off switch to turn the
Fig.
10
vacuum cleaner on/off.
Tip: If the vacuum can only be guided
with difficulty over carpeted areas
due to excessively high suction power,
adjust the suction power down by
opening the auxiliary air flap on the
handle.
Switch the vacuum cleaner off after use
Fig.
11
and unplug it when you have finished
working.
Fig. Wind the power cable around the
12
cable storage device by pressing the
automatic cable retraction switch. While
you are doing this keep the cable taut,
if possible.
Parking system for pauses in vacuuming
Fig. You can store the telescopic tube
13
with the floor nozzle on the vacuum
cleaner for short pauses in vacuuming.
Insert the floor nozzle with the parking
attachments into the parking system.

Transport and storage

To carry your vacuum cleaner grasp it
Fig.
14
by the handle. To store your vacuum
cleaner, the suction tube with the floor
nozzle can be mounted on the back
of the vacuum cleaner in an upright
position.
26/4/16 2:09 PM