Electrical Connections - Wiring Diagrams - Lamborghini Caloreclima Xilo D 24 MC W TOP U/IT Manual Para La Instalación Y El Mantenimiento

ELECTRICAL CONNECTIONS - WIRING DIAGRAMS

The boiler must be connected to an earthed, single-phase 230V-50 Hz mains supply by means of a three-wire
cable, ensuring that connections to the PHASE and NEUTRAL terminals are made correctly.
A bipolar switch must be used with contacts opening to at least 3 mm.
The power lead must only be replaced by another with the following characteristics: "HAR H05 VV-F" 3 X 1.00
mm . (You are strongly advised to use original LAMBORGHINI accessories and spare parts only).
2
Installation must be made in compliance with safety REGULATIONS IN FORCE.
Grounde connections are compulsory. Connect the boiler to an efficient grounding system.
Voltage Frequency
V Hz
50
230
To gain access to the electrical panel which houses the power supply terminal block and any connection to a
room thermostat, proceed as follows:
● Disconnect the boiler power
supply
● Undo the two grating screws
(fig. 1)
● Undo the two jacket fixing
screws (fig. 2)
● Raise the jacket and then pull it
towards you (fig. 3)
● To access electrical and
electronic parts loosen screws A
and pull the entire panel
outwards (fig.
downwards and undo the
screws B on the cover C
fig.3
All manuals and user guides at all-guides.com
Absorbed power
kW
MC
0,123
4). Tilt
fig.1
fig.4
A
Protection
index
MCS
IP
0,153
X 4D
A
Noise level
dB (A)
MC MCS
52 47
fig.2
fig.5
c
B
36