IV. Operation
4.1. CONTINUOUS VIDEO RECORDING
4.1.1. Please make sure you have chosen "Real Time" recording mode in 3.1. Once the bulb
camera is switched on, both blue and red indicator lights will come on and stay illuminated for
5 seconds, then the red one will turn off while the blue one will keep flashing. The camera will
start video recording automatically.
4.1.2. Press the Recording Button once to stop video recording. The blue indicator light will stay
illuminated, indicating the camera is back to standby mode.
4.1.3. If the camera is in standby mode without any operation more than 30 seconds, both blue
and red indicator lights will flash once and stay illuminated for 10 seconds, then the red one will
turn off while the blue one will keep flashing. The camera will start video recording again.
[Note]:
1). A video clip will be generated and saved every 30 minutes automatically.
2). Video Resolution: 640×480
Video Format: 3GP
3). Loop recording is supported.
4). Each video clip will take up to about 100MB storage space of the Micro SD card.
5). When the illumination is below 150 lux, the IR LEDs will turn on automatically. IR distance is 6
meters.
6). If no Micro SD card is fitted into the camera, both red and blue indicator lights will come on and stay
illuminated for 2 seconds, then the blue one will turn off while the red one will keep flashing. Every 15
seconds, the camera will check whether there is a Micro SD card is inserted and both red and blue indi-
cator lights will come on again.
7). The bulb camera has a built-in battery, which takes 4 hours to obtain a full charge. The camera will
work for 2 hours on a single charge.
4.2. MOTION DETECTION VIDEO RECORDING
4.2.1. Please make sure you have chosen "Motion Detection" recording mode in 3.1. Once