Publicidad
Idiomas disponibles
Idiomas disponibles
Only use extension cables with a sufficient cross-section. A cross-section
which is too small might cause a considerable drop in performance and an
overheating of machine and cable.
Before connecting the machine to the mains supply, make sure that
the machine is switched off.
Switching on and off
Switching-on:
press on/off switch on I
Switching-off:
press on/off switch on 0
Attention!
In case of every stop of the machine or a power cut , press the on/off
switch on 0. Consequently, you can avoid an unintentional restart of
the machine (physical hazard).
The ELS 225.1 has an adjustment wheel for stepless adjustment of the
speed between 1050 and 1600 min
It is located below the On/Off switch.
Tool Change
Attention!
Before the beginning of all works disconnect the plug from
the mains!
Only use original accessories in order to allow an optimal extraction.
Press the sanding paper in a way on the rubber foam pad that the
extraction holes are not covered.
The 6 hole punch of both discs makes it possible to centre exactly and to
position the sanding paper on the machine easily.
Changing the rubber foam pad and the base plate:
Rubber foam pad (Fig.1):
If existing, first remove the sanding paper and then the rubber foam pad
carefully.
When fixing the new pad, flange nut and punched holes of the base plate
make the positioning easier.
Base plate (Fig.2):
Remove the nut in the middle of the base plate by means of the enclosed
face spanner. If necessary, counter hold with a screw driver in the work
spindle.
Attention!
Before you start working, check whether the accessory has the exact
position. Let the machine start running in a safe position for a short
time.
In case the machine does not run easily, immediately stop
working.
.
-1
20
Publicidad
