Uline H-8348 Manual Del Usuario página 5

4. Place back panel inside side panels and top panel.
(See Figure 16)
Figure 16
5. Insert eight M6 x 12 mm bolts and M6 nuts and
fasten back panel to side panels and top panel
using a Phillips screwdriver. (See Figure 17)
M6 Nut
Figure 17
6. Attach front support channel to side panels with
four M6 x 12 mm bolts and M6 nuts using a Phillips
screwdriver. Attach front support channel to top
panel by fastening two M6 nuts to the welded bolts
on the top panel. (See Figure 18)
Figure 18
Front Support Channel
M6 x 12 mm
Bolt
PAGE 5 OF 15
ASSEMBLY CONTINUED
Back Panel
M6 x 12 mm
Bolt
M6 Nut
Welded Bolt
M6 Nut
1-800-295-5510
7. Place riser on rear of laminate top.
8. Attach five mounting brackets to base of riser with
five M6 x 10 mm bolts and M6 nuts. Fasten mounting
brackets to laminate top with five self-tapping
screws using a drill. (See Figure 19)
Figure 19
Second
Mail
Sorter
Mail
Sorter
9. Stack one mail sorter on top of riser. Fasten mail
sorter to riser with six M6 x 10 mm bolts and M6 nuts
using a Phillips screwdriver. Holes are located in the
front and rear of the sorter on the far left, center and
far right columns. (See Figure 19)
10. Stack second mail sorter on top of attached mail
sorter. Fasten together with six M6 x 10 mm screws and
M6 nuts using Phillips screwdriver. (See Figure 19)
NOTE: Mail sorter shelves may need to
be removed to allow for space for Phillips
screwdriver to fully tighten screws and nuts.
11. Assembly is complete.
NOTE: Knockouts in table and riser back panels
can be removed using a flathead screwdriver
and hammer.
uline.com
M6 x 10 mm Bolt
M6 Nut
M6 x 10 mm Bolt
M6 Nut
Mounting
Self-Tapping
Bracket
Screw
0721 IH-8348