GBS Elettronica Puma Instrucciones Operativas página 4

All manuals and user guides at all-guides.com
2. In the back section of this manual, find out the correct brand
name and code no. in the code list for your
device what you want to control (e.g. Lifetec 003,010,062, ...).
Note: the codes must be in the column for the corresponding
device group (TV).
3. Hold down the SET key and actuate the device key (e.g.
TV1) at the same time. The LED will be on at
the moment. Then release the pressed both keys.
4.You must enter into the 3-digit device code (e.g. 003 for
Lifetec TV) within 10 seconds now. If no entry
within 10 seconds, the setting up mode is terminated
automatically.
5.The LED goes out if the code has been accepted by the
universal remote control. If the LED flashes twice,
that means the code may be wrong, and the universal remote
control remains in set-up mode, you should
enter into the correct code from the list again in time.
6.Check the function of the keys on remote control. If most of
keys on your new remote control do not
function correctly, try another 3-digit device code (e.g. 010...)
from the list under the same brand.
Repeat step 3 to 6 until all the basic functions operate correctly.
Once you satisfy the code, that means you have already got
correct set up for the device.
Remark: To leave set up mode, press the device key (e.g.
TV1). Or if you do not actuate any keys
within 10 seconds, it will be terminated automatically.
You may set up more than one device on the new remote
control. Before you operate your new
remote control, please press the requested device key first (e.g.
TV1), so the remote control is surely at
the proper device status, otherwise it may control the wrong
device which did not requested by you.
B. Set up by Automatic Search
If setting up by brand name and codes is unsuccessful, or you
can not find your brand name in the list,
you can use the Automatic Search to find the correct code for
your remote control.
1.Switch on the device that you like to control. If it is a video
recorder, please insert a video cassette.
2.Point the remote control at your device. Press the SET and
the device (e.g. TV) keys
simultaneously and hold them down for 3 seconds. Then the
LED flashes, that means it is in Automatic
Search now.