KEKAI Slim Black Manual De Instrucciones página 10

26. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable
liquids are used or stored.
27. Parts of the heater may exceed 200 , contact with the heating tube, reflector, or metal parts near the heating tube,
may cause severe BURNS . To avoid burns, do not let bare skin touch hot surface.
28. NEVER place hands under the heating elements. ALWAYS allow heating element to cool at least 10 minutes before
touching the heating tube or adjacent parts.
29. This product contains recyclable materials. Do not dispose this product as unsorted municipal waste. Please con-
tact your local municipality for the nearest collection point.
SAVE THESE INSTRUCTIONS
Introduction
The SUNDEAR MINI infrared heaters produce instant and comfortable heat like the sun. These robust and weatherproof
heaters are designed for domestic and commercial heating applications at outdoor well-protected areas.
Model
Voltage(V)
Wattage(W)
Hertz(Hz)
Dimensions W×H×D(mm)
Weight(KG)
INSTALLATION
-
Tools Needed:
* Pencil *Hammer
A wall mounting bracket is provide with the heater which has been specifically designed to allow this product to be fitted
to a ceiling before drilling the holders for the ceiling is solid and that there are no hidden water pipes or electric wires.
The heater must be installed no less than 1.8m from side walls and no less than 2.4m off the floor.
ATTENTION!
The appliance must be installed on the solid surfaces like concrete, wood or metal etc.
Important: Ensure that the supply cables is well mounted and that it does not come into contact with reflector of the
heater or that does not trail into heated area, the supply cable can be fixed to the metal mounting bracket behind heater
with plastic zip ties.
1. This heater should be installed by a competent person, i.e. a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before installation.
3. For ceiling mounting, the lowest part of the heater must be located at or above a minimum height of 1.8m from ground
level, so that the heater can not be touched when in operation.
4. For ceiling mounting, there must be a 1.8m distance from your appliance to the ground.
5. When installed to the ceiling, there must be a distance of 0.5m between corners and the appliance.
6. The distance of your appliance from the living beings is to be min 1m.
7. The distance from the front side of the heater to materials such as wood, carton, cloth etc., must be min 1m.
8. When mounting to a ceiling, do not position the heater at an angle more than 90°
9. The supply cable must be at the lower end of the heater if the heater is installed at an angle or vertically.
10. Keep the supply cord away from the body of the heater which will get hot during use.
11. Do not install the heater on an inflammable surface.
12. Observe the minimum safe distance between the heater body and the inflammable surfaces when mounted.
13. The heater should always have a minimum clearance of 0.5m from a ceiling and adjacent walls.
14. If the heater is to be used outside, a weatherproof outlet is recommended.
15. Before drilling ensure that there are no wires or water pipes in the area where the heater is to be installed.
16. The heater must be installed on the mounting brackets provided.
SUNDEAR MINI
220-240V AC
2000
50-60
460×190×75
2.2
*Level *Screw Driver *Power Drill and drill bits