Epson EasyMP EMP-1715 Guía De Conexión Rápida página 9

5
Select the projector you want to connect to.
6
Click the "Connect" button.
7
If the keyword entry screen is displayed, enter
the projector keyword (four digits) that is
projected on the EasyMP screen, and click
"OK".
The computer and the projector are connected via the network.
The EMP NS Connection tool bar is displayed on the computer
screen. You can use this tool bar to operate the projector, make
settings, and disconnect from the network.
Stop/Show/Pause
(When connected to the projector)
Project a PowerPoint slide show
only (Presentation Mode)
When the target projector is not found
Check that the projector's power supply is on
and that the EasyMP screen is displayed. It is
also possible that the electromagnetic waves of
the wireless LAN are too weak to reach. Check
that the projector is not too far away.
When the following message is displayed when you click the "Enter" button
"The selected projector is busy. Do you want to continue the connection process?" Because
interrupt is prohibited you cannot connect while the selected projector is connected to another
computer.
Screen during connection
Projector control
Multi-screen display Preview
When there are too many projectors displayed
You can narrow the search by performing the
following operation.
1 Click "Manual search".
2 Enter the ESSID for the target projector and
click the "Enter" button.
(Procedure 5)
Set options Movie Sending Mode
(Procedure 6)
9