Before You Start - AEG FFS2 Guía De Uso Y Cuidado

TABLE OF CONTENTS

BEFORE YOU START

SPECIFICATIONS AND DIMENSIONS
PARTS & TOOLS
TYPICAL UNDERSINK INSTALLATION
INSTALLATION INSTRUCTIONS
Step A - Install Water Supply Fittings
Step B - Make Tubing Connections
Step C - Install the Filter Cartridge
Step D - Turn On Water, Check for Leaks and Rinse Carbon Fines
FILTER CARTRIDGES
FILTER CARTRIDGE LIFE
FILTER CARTRIDGE REPLACEMENT
TROUBLESHOOTING THE SYSTEM
EXPLODED VIEW & PARTS LIST
All manuals and user guides at all-guides.com
37
37
37
37
39
39
39
40
40
41
41
41
42
42
36
BEFORE YOU START
• Read all steps and guides carefully before installing and using your undersink full flow water filtration
system. Follow all steps exactly to correctly install. Reading this manual will also help you to get all the
benefits from the filtration system.
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. This system is certified for cyst reduction and may be used on disinfected
waters that may contain filterable cysts.
• All plumbing should be done in accordance with local codes and requirements.
• The undersink full flow water filtration system works on water pressures between 2.1 bar and 6.9 bar
(between 30 psi and 100 psi). If your house water pressure is over the maximum, install a pressure
reducing valve in the water supply pipe to the filtration system.
• Do not install the filtration system outside, or in extreme hot or cold temperatures. Temperature of the
water supply to the filtration system must be between 4°C and 38°C (between 40°F and 100°F). Do
not install on hot water.
SPECIFICATIONS & DIMENSIONS
Supply Water Pressure Min. - Max 2,1 - 6,9 bar
Supply Water Temperature Min. - Max. 4 - 38°C
Rated Service Flow 7.6 liters per minute
Inlet - Outlet 9.5 mm (3/8») quick connect fittings and tubing included
1"
2,5 cm
4"
10,2 cm
14-1/2"
36,6 cm
3"
7,6 cm FIG.1
37