Functions With Ptt Switch; Technical Characteristics - PRESIDENT ANDY USA 12/24 V Manual Del Usuario

- Turn on the power while pressing the t key (2b) to enable (BP on)
or disable (bP oF) the KEY BEEP function.
- When function is activated, "BP" appears on the display.
3) TOT (Time Out Timer)
(CB/PA key)
If the transmission key is longer than 5 minutes, CHANNEL and ac-
tivated or deactivated
The time-out tone will sound until the PTT key is released.
The TOT function can be activated or deactivated as follows:
- Turn on the power while pressing the CB/PA key (6) to enable (t
on) / disable (t oF) the TOT function.
4) COLOR
(EMG + CB/PA keys)
- Turn on the power while pressing the EMG (5) and CB/PA (6) keys.
Symbol of the current color, among the seven, blinks,
(green), (blue), (cyan),
light).
- Use the s/t keys (2) to change the color.
- When the color is set, long press the F key (5). Beep sounds, the
characters of the color are displayed during 1 second.
D) FUNCTIONS WITH PTT SWITCH
2 more functions are available. To activated the function press
and hold the PTT switch (8) and press the function key. Repeat this
process to deactivate the function.
1) TALKBACK
(PTT + F)
The TALKBACK function can be activated or deactivated as follows:
a) Press and hold the PTT switch (8)
b) Short press on F key (5). Current TALKBACK level blinks 3 times al-
lowing you to adjust this level.
When function is activated, "TALKBACK" appears on the display.
This function allows to ear your own modulation with the CB speaker.
start blinking, the transmission ends.
(yellow), (purple) or
2) TALKBACK LEVEL
- At step b) adjust the TALKBACK level using the s/t keys (2) on the
unit.
- When the function in on and "TALKBACK" is shown on the display,
press and hold the PTT switch (8), then use the s/t keys (2) on the
unit. 9 levels from 01 to 09.
A) DC-POWER TERMINAL (13.8 V / 27.6 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3,5 mm)
D) PA SPEAKER JACK (8 Ω, Ø 3,5 mm)
E) TECHNICAL CHARACTERISTICS
(red),
1) GENERAL
(cyan
- Channels
- Modulation modes
- Frequency ranges
- Weather channels
- Antenna impedance
- Power supply
- Dimensions
- Weight
- Accessories supplied
- Filter
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Maximum drain
- Modul. signal distortion
10
(PTT + s/t)
: 40
: AM
: from 26.965 MHz to 27.405 MHz
: 162,400 MHz to 162,550 MHz
: 50 ohms
: 13.8 V / 27.6 V
: 4.92 (W) x 6.89 (D) x 1.77 (H) inches
125 (W) x 175 (D) x 45 (H) mm
: ~ 1.98 lbs / 0.9 kg
: Electret microphone with support,
mounting cradle, screws
: ANL (Automatic Noise Limiter) built-in
: +/- 200 Hz
: 4 W RMS
: inferior to -60 dBc
: 300 Hz to 3 KHz
: inferior to 20 µW
: 3 mV
: 1.8 A at 13.8 V / 0.9 A at 27.6 V
: 1.8 %