Publicidad
Idiomas disponibles
Idiomas disponibles
Setting
Step 1: Setting the Drilling Depth (Depth Collar Adjustment)
Measure the thickness of workpiece firstly, then Insert the Slider Piece in the
downward position, read and set the Timber Thickness Scale according to the
measured thickness of workpiece (see FIG. 1).
Note: Recommended workpiece thickness range from 1/2" (12mm) to 1-1/2"
(38mm).
Rest the Stepped Drill Bit on the Stop Collar Recess, set the Step of the drill bit to
align with the scale matches the workpiece thickness. To drill in 3/4" (19mm)
material for example, set the Timber Thickness Scale at 3/4"(19mm), and align the
Step of the drill bit at the position of 3/4"(19mm) (see FIG. 2)
Then simply slide the Depth Collar onto the drill bit shank and using the Allen
Wrench to tighten the Stop Collar (see FIG. 2)
FIG. 1
Step 2: Drilling the Holes
Simply make the end of slider piece
stick to the edge of material, before drill
your first pocket holes, first clamp the
jig to the workpiece with a Face Clamp
or a similar woodworking clamp (see
FIG. 3). Insert the tip of the drill bit half
way into the Drill Guide. Start the drill to
full speed, and plunge the drill into the
guide until the Depth Collar contacts
the rim of the Drill Guide. Back the drill
out and let the bit stop turning.
GB
FIG. 2
FIG. 3
3/4" (19mm)
Workpiece
4
End of slider
piece stick to the
edge of material
Publicidad
