WorkPro W124696A Manual Del Usuario página 5

CAUTION: Never attempt to hold the jig in your hand when drilling. The tool
must be clamped to the wood for this step. Failure to follow these instructions could
result in personal injury and/or damage to the tool(s).
Step 3: Assembly / Driving Pocket Hole Screws
Assembly / Driving Pocket Hole Screws, If you are using a Face Clamp to assemble
the joint place the large pad of the clamp on the face side of the joint (see FIG. 4).
Be sure that both pads are equally balanced over each workpiece at the joint line.
Adjust the closure pressure until the two parts are firmly secured. The Face Clamp
will keep the face surface of the two pieces flush with each other during assembly.
It is recommended to drive the screws with a cordless drill/driver that has an
adjustable clutch. Start with a light clutch setting and adjust torque as necessary to
seat the pocket hole screw. Because the hardness varies among wood species,
plywood and composites, drive a few "test" screws to select the proper clutch
setting on your drill for the material you are assembling.
FIG. 4
Joint Line
Face Side
Large Pad
GB
5