Publicidad
Idiomas disponibles
Idiomas disponibles
THESE INSTRUCTIONS SHOULD NOT BE FAXED OR REPRODUCED ON A DIGITAL COPIER. AMERICAN WOODMARK CORPORATION PROVIDES THESE INSTRUCTIONS ON AN "AS IS" BASIS AND DISCLAIMS ANY AND
ALL LIABILITY FOR ANY INACCURACIES, OMISSIONS OR TYPOGRAPHICAL ERRORS CAUSED BY ANY THIRD PARTY'S EQUIPMENT. When you use these instructions, you are consenting to be bound by the provisions
in this paragraph. These instructions provide an illustrative method for installing American Woodmark Corporation ("AWC") cabinets and/or accessories. AWC's instructions are not intended to address every possible
contingency that might be encountered during installation or to endorse the use of any particular tools. AWC HEREBY EXPRESSLY DISCLAIMS ALL LIABILITY FOR ANY CLAIMS FOR INJURY OR DEATH RELATED TO OR
BASED UPON THE USE OF THESE INSTALLATION INSTRUCTIONS AND ANY INSTALLATION INSTRUCTIONS OTHERWISE PROVIDED BY AWC.
Installation Instructions
TV3030 and TV3630 Mirror Door Installation
This kit allows you to install mirror doors in
the TV3030 and TV3630 cabinets.
Contents
• (1) TV3030 or TV3630 Cabinet
• (3) Mirror Doors
• (3) Sets of Hinges
• (6) Plastic Bushings
• (3) Striker Plates/Door Pulls
• (3) Foam Liners
Tools Needed
• Phillips Screwdriver
• Hammer
• Safety Glasses
All manuals and user guides at all-guides.com
Procedure
Gently tap the plastic bushings into the
1
top and bottom of the face frame. See
Figure 1.
Place hinges into the plastic bushings
2
that were installed in Step 1. Be sure
that the hinges are oriented so that the
set screws are towards the inside of the
cabinet. See Figure 2.
Set Screw
Figure 2
Insert the doors into the hinges so that the edge of the door is flush with the edge of
3
the hinge. Tighten the set screws on the back of the hinge being careful not to over
tighten the set screws. This may damage the door. See Figure 3.
Check the spacing (approximately 1/8") between the mirror doors. Make adjustments
4
as needed.
Peel off the paper backing from the foam
5
liner and wrap the liner around the
bottom edge of the door flush with the
edge that is furthest away from the
hinge. See Figure 4.
Push the striker plate/door pull onto the
6
foam liner. The striker plate should be
flush with the edge of the door. See
Figure 4.
Read carefully before you begin installation
Figure 1
Hinge
6 Required
Face Frame
Set Screw
Figure 3
Peel Backer
Wrap Foam
Liner
Figure 4
Plastic Bushing
6 Required
Face Frame
Mirror Door
Hinge
Magnetic
Striker
Latch
Plate
99873 8/07
Publicidad
