Receiver Programming - LD Systems MEI1000G2 Manual De Usuario

3
4
SELECTING THE OPERATING MODE
Press the SET button repeatedly until "MODE SELECT" appears in the display. With the
and stereo mode. Select the mono mode if only one (mono) audio signal is to be transmitted to the receiver. The signal is located on two
channels (left/right) of the receiver. In the mono mode, only the right input (INPUT RIGHT) may be used. Select the stereo mode if either a
stereo signal, or two mono signals are to be transmitted to the receiver. Please refer to the notes in the Stereo and Focus Mode chapter.
4
5
LOCK AGAINST INADVERTENT CHANGES
Press the SET button repeatedly until "LOCK SELECT" appears in the display. Press the keys
SELECT is enabled, the system settings can be viewed, but not changed.
EXIT THE SETUP MENU
Press the SET button repeatedly until "EXIT SETUP" appears in the display. Press the keys
are pressed, the display switches automatically to the main menu after a few seconds.

RECEIVER PROGRAMMING

To change settings on the receiver, press gently on the marked spots on the sides of the battery cover and flip it forward. The Escape
(ESC) and SET buttons are now accessible. To return to the main menu after a setting change, press the Escape button (ESC).
1
1
MAIN MENU
In the main menu, the radio frequency, RF and AF level, mono / stereo mode, EQ, limiter, as well as the lock status are displayed.
2
2
BALANCE
Adjust the volume balance between the left and right channels of a stereo signal using the
mono mode, using the
10
buttons will set the position of the signal in the panoramic field.
buttons, you can now choose between mono
to lock or unlock the system. If "LOCK
to exit the menu. If no control buttons
buttons. When the transmitter is in