System Setup - LD Systems MEI1000G2 Manual De Usuario

4
LC DISPLAY
Backlit LC Display. The back light automatically turns off after about 30 seconds if no control buttons are pressed; the back light is turned on when
any of the control buttons is selected. See Chapter "System Setup".
5
LOW BATT LED
LED lights when the battery charge is low. Please replace the batteries as soon as possible.
6
RF SIGNAL LED
Lights up briefly when you switch on. Lights up when a HF signal is present. Radio frequency of both transmitter and receiver must match.
7
ARROW UP, INCREASE VALUE
See Chapter "System Setup".
8
ARROW DOWN, DECREASE VALUE
See Chapter "System Setup".
9
ESC-BUTTON
Press this button to return to the main menu.
10
SET BUTTON
See Chapter "System Setup".

SYSTEM SETUP

TRANSMITTER PROGRAMMING
1
MAIN MENU
In the main menu the radio frequency, the operating mode (mono/stereo) and signal level (AF L and AF R) are displayed.
1
2
SELECTING A FREQUENCY GROUP
Press the SET button repeatedly until "GROUP SELECT" appears in the display. Press the keys
group.
2
3
SELECTING A CHANNEL
Press the SET button repeatedly until "CHANNEL SELECT" appears in the display. Press the keys
Note: For simultaneous operation of several systems, please make sure that all the systems use different channels on the same frequency group.
to select the desired frequency
to select the desired channel.
9