Filling The Tank; Temperature Setting - TREVIDEA g3ferrari TUTTOVAPORE Manual Del Usuario

- Adjust the quantity of steam using the knob (4). For using the steam, either horizontally or vertically, press
the button (13). Use the button (11) to supply continuous steam.
CAUTION: when using the steam, wait for the complete heating of both the iron and the
boiler. In the beginning, few drops will come out together with the steam. This is normal and
it is due to the heating of the cable connecting the boiler and iron.
CAUTION: do not completely fill the tank of the boiler (max 1 liter), since this operation prevents the
formation of the steam, causing the loss of water from the iron. CAUTION: if the pressure gauge (2)
exceeds 3,5 Bar reaching the "red zone", immediately turn off the system.

FILLING THE TANK

Use of distilled water is recommended to avoid excessive fouling (not covered by warranty).
The capacity of the tank is 1 liter. It is compulsory filling up the tank when it comes out of water or when the
indicator light (9) turns off during use. Follow the steps below for filling the tank:
1) Stop the heating boiler by switching the control knob (5) to position "0".
2) Let the steam comes out from the boiler by pressing the button (13).
To avoid any risk of injury, always eject the steam before opening the cap of the boiler.
3) Remove the plug from the main power outlet and wait until the pressure gauge goes down.
4) Slowly unscrew the boiler cap (15) to release remaining steam and lower the pressure. The air coming
out is very hot, be careful and unscrew the cap of the boiler very slowly.
5) Fill in the tank using the cup and the funnel without exceeding the maximum capacity.
CAUTION: do not completely fill the tank of the boiler (max 1 liter), since this operation
prevents the formation of steam causing the loss of water from the iron.

TEMPERATURE SETTING

The following table provides a guideline on how to adjust the thermostat according to the international
symbols printed on the clothing labels or according to the type of fabric.
•
It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since the ironing plate heats faster than it cools down.
•
In the case of blend fabric(Ex: Acrylic and cotton), it is recommended to select the temperature
according to the fabric that requires the lowest.
•
When you do not know the composition, it is recommended to iron a non-visible part of the it, starting
from the lowest temperature to find the most suitable temperature.
•
Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate
and the fabric.
Setting the temperature
Place the iron on the insulated rubber housing above the boiler.
Plug the system to the electrical outlet, and switch the power button (6) to "1" position.
Select the temperature regulator (12) according to the symbols shown on page 7. The chosen symbol has to be
LABEL FABRIC
Synthetic
(Acrylic, nylon...)
silk – wool
cotton – linen
TEMPERATURE
·
Low temperature
··
Medium temperature
···
High temperature
Do not iron
13