Uline H-2506 Manual De Instrucciones página 2

Mounting Post x 1
1. Place stool upside down on a flat surface. Align
mounting plate with four holes closest to seat center
where the legs cross. (See Figure 1)
Figure 1
2. With flat side of mounting plate facing seat, use four
mounting screws (1) to attach loosely, threading only
halfway. Do not secure. (See Figure 2)
Figure 2
NOTE: Screws may be difficult to thread initially.
In this case, extra force may be necessary.
Since screws are self-threading, they re-thread
holes as necessary.
PAGE 2 OF 9
BACKREST PARTS
Backrest x 1
Mounting Plate x 1
BACKREST ASSEMBLY
3. Slide mounting post in slot between seat and
4. Fully tighten four mounting screws (1) installed
5. Thread knob (3) into center hole in mounting plate.
1
Mounting Screw x 4
3
Plastic Knob x 1
mounting plate. Indentation on post must align with
offset hole in mounting plate. Use set screw (2) in
offset hole to secure. (See Figure 3)
Figure 3
in step 2.
Set post at preferred seat depth and tighten knob to
secure. (See Figure 4)
Figure 4
2
Set Screw x 1
4
Bolt and Washer x 1
0521 IH-2506