Testing The Ys Vibe; Operating Modes - Dogtra YS VIBE Manual Del Usuario

TESTING THE YS VIBE

LED
1. Make sure the YS VIBE is turned off.
2. Hold the on/off button down for 4 seconds.
3. Release the on/off button when the green LED light
blinks rapidly.
4. Blow into the Mic Sensor so that the receiver will emit a
High Performance Pager vibration three times.
26
Mic Sensor

OPERATING MODES

1. High Performance Pager (HPP)
The YS VIBE has three High Performance Pager (HPP)
vibration levels. With the YS VIBE on, briefly press the
on/off button to increase the level. When the YS VIBE is
turned off, the last level that the system was on will be
saved. If the incorrect level is selected, you can press the
on/off button to start over.
2. Safety Time:
The YS VIBE has a preset delay of 4 seconds in between
the vibrations even if the dog continuously barks. The
reason for the delay is so that your dog figures out the
implications of the corrections from barking.
3. Sleep Mode:
If there is no barking for 12 seconds or more, the system
will go into sleep mode. There will not be any LED light
during sleep mode. If the dog barks again, the LED light
will turn back on.
27