Publicidad
Step 18
Diagram 1. Place the RIGHT BACK (N) into the lower edge of the RIGHT REAR LEG (H) with the top edge of the RIGHT
å
BACK against the bottom surface of the TOP (T).
Diagram 2. Place the bead of the nail holder down between the RIGHT BACK (N) and RIGHT REAR LEG (H) 2" from the
å
corner. Place a NAIL (1N) into the nail slot of the nail holder. Tap the nail through the BACK and into lower edge of the
RIGHT REAR LEG. Remove the nail holder from the nail and completely tap the nail in with your hammer. Finish fastening
the BACK to the RIGHT REAR LEG with the hammer and nail holder placing nails approximately 6-1/2" apart.
Diagram 3. To fasten the opposite edge of the RIGHT BACK (N), place the off set edge of the nail holder down 2" from
å
the corner. Place a nail into the nail slot of the nail holder. Tap the nail through the RIGHT BACK and into edge of RIGHT
UPRIGHT (J). Remove the nail holder from the nail and completely tap the nail in with your hammer. Finish fastening the
BACK to the RIGHT UPRIGHT with the hammer and nail holder placing nails approximately 6-1/2" apart.
Diagram 4. Fasten the bottom edge of the RGHT BACK (N) to the RIGHT BRACE (R). Use two CLIPS (67G) and two
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
2.
2"
Lower edge
1.
4.
67G
Page 22
nail
holder
Bead
6- 1/2"
H
R
J
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
Off set edge
Nail slot
N
6- 1/2"
1S
NAIL
(8 used in this step)
420654
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
2"
T
1N
www.sauder.com/services
3.
Publicidad
