Ribimex Ribiland PR4EN1T Manual De Instrucciones página 50

All manuals and user guides at all-guides.com
d. If any fuel spillage occurs during refueling, use a dry rag to wipe up spills before turning the
engine back on again.
e. After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the brush cutter to
a spot 3m or more away from where it was refueled before turning on the engine.
3.3.4- Things to check before using your brush cutter
a. Before beginning work look around carefully to get a feel for the shape of the land, or grass to be
trimmed and whether or not there are any obstacles, which might get in the way while working, and
remove any obstacles which can be cleared.
b. The area within a perimeter of 15m of the person using the brush cutter should be considered a
hazardous area into which no one should enter while the brush culler is in use, and when necessary
yellow warning rope, warning signs should be placed around the work area. When work is to be
performed simultaneously by two or more persons, always check the presence and locations of others
so as to maintain a safety distance between each person.
c. Make sure that there are no loose screws or bolts, fuel leaks, ruptures, dents, or any other problems,
which might interfere with safe operation. Be especially careful to check that there is nothing wrong
with the blades / nylon wire or with the joints by which the blades / nylon wire are attached to the
brush cutter.
d. Never use blades that are bent, warped, cracked, broken or damaged in any way.
e. Keep the blade always sharp.
f. Filing the cutting edges, keep the end corner sharp and round the root of the edge.
g. Check the bolt to fasten the blade and be sure the blade turns smoothly without abnormal noise.
3.3.5- Notes on starting the engine
1. Take a careful look around to make sure that no obstacles exist within a perimeter of 15m or less
around the brush cutter.
2. Place the body of the brush cutter onto the ground in a flat clear area and hold it firmly in place so
as to ensure that neither the blades / nylon wire nor the throttle come into contact with any obstacles
when the engine starts up.
3. Place the throttle into the idling position when starting the engine.
4. After starting up the engine, if the blades continue to rotate even after the throttle has been moved
fully back, turn off the engine and check the throttle wire and other parts.
3.3.6- Kickback safety precautions
A dangerous reaction may occur when the spinning blade contacts a solid object in the critical area.
It is called kickback. As a result, the operator can lose control of the unit, which can cause serious or
fatal injury. Avoid kickback; observe the safety precautions below strictly.
1. Before beginning work, clear your working area and remove grasses around the obstacles.
2. When using your brush cutter, do no grip other parts except the handles.
3. When using your brush cutter, never take your eyes off, even if you need to place the throttle into
the idling position.
4. When using your brush cutter, do not let the unit get closer to your feet nor raise the unit above
your waist
3.3.7- Notes on transportation
1. Make sure the appropriate blade cover is in place.
2. When transporting by car, fix the unit firmly using a rope.
Do not transport by bicycle or motorcycle as it is dangerous.
3. Never transport the brush cutter over rough roads over long distances without first removing all
fuel from the fuel tank, as doing so might cause fuel to leak from the tank.
3.3.8- Operation safety precautions