Troubleshooting - Cub Cadet SCP21E Manual Del Operador

Problem
Battery will not charge
Mower fails to start
Battery dies quickly
Mower stops while mowing
Excessive vibration
Mower will not mulch grass
Uneven cut

TROUBLESHOOTING

Cause
1. The battery charger is not plugged in.
2. The battery is not fully inserted into the
battery charger.
3. The battery and/or charger are too hot or
too cold.
4. The battery and/or charger are no longer
functional.
1. Push start safety key not inserted into
starter housing.
2. Blade control disengaged.
3. Starting procedure incomplete or performed
out of order.
4. Battery discharged.
5. The battery is not installed correctly.
6. Mower deck clogged with grass and debris.
1. The battery is not fully charged.
2. The battery and/or charger are no longer
functional.
3. Using unit outside temperature range.
1. Battery discharged or lacks sufficient
charge.
2. Cutting too much grass.
3. Clogged deck.
4. Battery is over heated
5. Using unit outside temperature range.
1. Cutting blade loose or unbalanced.
2. Bent cutting blade.
3. Bent motor shaft.
1. Mower deck clogged.
2. Wet grass.
3. Excessively high grass.
4. Dull blade.
1. Dull blade.
1. Plug the battery charger into a 120V 60hz
AC source.
2. Remove and then reinsert the battery into
the battery charger.
3. Make sure the battery and charger are in an
environment between 32° and 104° F (0°
and 40° C). Allow time for the battery and/or
charger to warm up or cool down.
4. Refer to the Warranty Supplement for
replacement information.
1. Insert push start push start safety key fully
into starter housing.
2. Engage blade control.
3. Press blade control against the handle
then press the push start safety key to start
motor.
4. Charge battery.
5. Remove and reinstall battery.
6. Unclog mower deck. Make certain blade is
free to move.
1. Charge the battery completely.
2. Refer to the Warranty Supplement for
replacement information.
3. Allow battery to cool.
1. Charge battery completely.
2. Raise cutting height.
3. Unclog mower deck. Raise cutting height or
cut a narrower swath.
4. Allow battery to cool.
5. Allow battery to cool.
1. Tighten blade and adapter. Balance blade.
2. Replace blade.
3. Contact nearest authorized service center.
1. Unclog mower deck. Make certain blade is
free to move.
2. Do not mow when grass is wet; wait until
grass is dry to cut.
3. Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting swath (1/2 width).
4. Sharpen or replace blade.
1. Sharpen or replace blade.
18
Remedy