Safety Notes; Important Notes; Functions; General Notes - marklin 39935 Manual Del Usuario

Safety Notes

• This locomotive is to be used only with an operating
system designed for it (Märklin Delta, Märklin Digital or
DCC).
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one transformer.
• Pay close attention to the safety notes in the
instructions for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• It is not necessary to open the locomotive for mainte-
nance work. Disassembling the locomotive automatically
invalidates the manufacturer warranty. Please see your
authorized Märklin dealer for repairs or spare parts.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
6

Functions

• Recognition of the mode of operation: automatic.
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: Unimat P&T
• Address set at the factory: MM 09 / DCC 03
• Setting the locomotive parameters (address, accelerati-
on/braking delay, maximum speed):
with the Control Unit, Mobile Station, Central Station.
• Headlights, changing over with the direction of travel.
• Various controllable functions.

General Notes

• This model has only limited operation possible with the
Mobile Station 1 (MS1)!
• The digital protocol with the most possibilities is the
highest order digital protocol. The sequence of digital
protocols in descending order is:
Priority 1: mfx
Priority 2: DCC
Priority 3: MM
If two or more digital protocols are recognized in the
track, the decoder automatically takes on the highest
value digital protocol.For example, if mfx & MM are
recognized, the mfx digital protocol is taken on by the
decoder. Individual protocols can be deactivated with
Parameter CV 50.