Publicidad
Operating Instructions:
To operate your Ultra Air Deodorizer, the A/C or the D/C Adapters must be plugged into
the power input port (#6 in photo 4). You use the Flip Plug of the A/C Adapter (#9 in photo
5) to plug the Ultra Air directly into a 110V or 220V A/C power source (photo 6). Once
the adapter is connected to the 110V or 220V power source, simply press the on/off but-
ton (#3 in photo 2). This will access the first setting (#4a in photo 2). On this setting, the
Ultra Air will operate on a 15 minutes on/15 minutes off cycle.
To access the 2 hour (#4b in photo 2) run time press the on/off button a second time. Press
it a third time and you will access the 4 hour (#4c in photo 2) run time. The 24 hour (#4d
in photo 2) run time is accessed by pressing the on/off button the fourth time. Once the 2
or 4 or 24 run time settings complete their run time, the Ultra Air will automatically shut-
off. Please note that each time the on/off button is pressed, it passes through each of the
settings. When the on/off button is pressed five times you will have passed through the run
time settings cycle and on the sixth press, the Ultra Air Deodorizer will shut off.
Use switch (#5 in photo 3 ) to set the Ultra Air's output on a Hi or Lo operation setting.
To operate Ultra Air in an automobile, boat, RV, or any other location powered by DC cur-
rent, you must use the 12V D/C Auto Adapter provided (photo 9) and then follow the same
operating instructions shown above.
Caution:
People have different levels of sensitivity to ozone ("activated oxygen")
whether it is naturally occurring or generated. Using the Ultra Air Deodorizer responsi-
bly should be of uppermost consideration. Do not operate the Ultra Air in confined spaces
for long periods of time, especially when that space is being occupied. It is best to use
Ultra Air when the space is unoccupied.
Wall Assembly:
Your Carico Ultra Air Deodorizer can be mounted onto
a wall surface providing there is a 110V or 220V power
supply source outlet close enough to plug in the A/C
Adapter. Using your thumb, lift the Flip Plug and
remove the A/C Adapter (photo 7) from the back of the
Ultra Air. By using your thumb again, release the latch
clip (photo 8) and with the other hand gently pull the
A/C Adapter out by grasping one of the plug's prongs .
Leave the cord plugged into the power supply port (#6
photo 4). Once the wall surface location is determined,
note the slotted fittings on the underside of the unit
(#10 in photo 5). Follow the template instructions pro-
vided and mount Ultra Air onto a flat wall surface using
the sized screw heads provided or nail heads that allow
the slotted fittings to slide over them easily and yet stay
securely affixed to the wall surface location selected.
Plug the A/C Adapter into the wall outlet to operate
your Ultra Air. No other assembly is otherwise recom-
mended since the unit is designed to sit on a tabletop, a
desk or a shelf.
PHOTO 7
4
PHOTO 8
Publicidad
