Controls, Indicators And Connections; Inspections Prior To Starting; Starting Up; Starting/Stopping The Vacuum Cleaner - Blastrac BDC3140 DB Manual De Instrucciones

Instruction Manual BDC3140 DB/LP

Controls, indicators and connections

1.
Dust container release lever
2. Castor lever
3. Manual filter shaker knob
4. Start/stop switch

Inspections prior to starting

1. Inlet
Prior to starting, check that:
■ The filter is installed.
■ All latches are tightly locked;
■ The vacuum hose and tools have been correctly fitted
into the inlet (1);
■ The bag or safety container is installed, if applicable.
Do not use the vacuum cleaner if the filter is faulty.

Starting up

1. Castor brakes
2. Start switch
Lock the castor brakes before starting the vacuum cleaner
(1).
Starting/stopping the vacuum
cleaner
■ Turn the switch (2) to "I" position to start the vacuum
cleaner.
■ Turn the switch to "0" position to turn the vacuum
cleaner off.
Checking the rotation direction of the
vacuum unit motor
GB
Check the vacuum cleaner operation by putting a hand on
the inlet.
If the vacuum cleaner expels the air from the vacuum hose,
the rotation direction is not correct; remove the plug from
the socket and turn the selector inside the plug to perform
the correct phase connection.
Figure 4
Figure 5
Figure 6

Shaking the primary filter (Fig. 7)

Depending on the vacuumed dust quantity and if the pointer
of the vacuum gauge switches from the green zone (2) to
the red zone (3) turn the vacuum cleaner off and shake the
main filter with the knob (1).
WARNING!
Stop the vacuum cleaner before shaking the filter.
Do not shake the filter while the vacuum cleaner is
on, as this could damage the filter itself.
Wait before restarting the vacuum cleaner, to allow the
dust to settle. Replace the filter element if the pointer still
remains in the red zone (3) even after the filter has been
shaken (consult the "Primary filter replacement" paragraph).

Emergency stopping

Turn the main switch to "0" position.

Emptying the container

WARNING!
Before proceeding with these operations, turn off
the vacuum cleaner and remove the plug from the
power socket.
Before emptying the container it is advisable to clean the
filter (see "Shaking the filter" paragraph).
Figure 8
1. Dust container
■ Release the container (1), then remove and empty it.
■ Make sure the seal is in perfect condition and correctly
positioned.
■ Place the container back in position and secure it again.
www.blastrac.eu ‒ info@blastrac.eu
8/16