TFA 30.3014 Manual Del Usuario página 32

SNOOZE SETTING AND STOPPING THE ALARM:
1. When the alarm is sounding, press the SNZ to activate the snooze function. The alarm will stop and re-activate
after the snooze interval of 9 full minutes.
2. To stop the alarm completely, press any keys other than the SNZ
LCD 3 INDOOR TEMPERATURE: Minimum display
The indoor temperature is measured automatically and displayed on the third section of the LCD.
TOGGLING AND RESETTING THE INDOOR RECORDINGS:
1. To toggle between the indoor current, minimum and maximum temperature data and the times at which they
were recorded, press the IN key:
Once to show the minimum temperature values with time and date recorded.
Twice to show the maximum temperature values with time and date recorded.
Three times to return to the current time, date and temperature levels.
2. To reset the minimum and maximum temperature data and the times at whic h they were recorded, press the IN
key continuously for about 3 seconds. This will reset all minimum and maximum data recorded to the current
time, date and temperature. The min/max temperatures recorded are of current time and they remain unaffected
by the time zone setting.
LCD 4 OUTDOOR TEMPERATURE:
The fourth LCD section shows the outdoor temperature and a transmission signal. A number besides the temperature
will also show if more than one transmitter is used.
key.
Indoor temperature in °C
Outdoor temperature in °C
Number showing the
transmitter unit (only if there
is more than one transmitter)
TOGGLING AND RESETTING THE OUTDOOR RECORDINGS:
1. To toggle between the outdoor current, minimum and maximum temperature data and the times at which they
were recorded, press the OUT key:
Once to show the minimum temperature value with time and date recorded
Twice to show the maximum temperature value with time and date recorded
Three times to return to the current time, date and temperature level
2. To toggle between transmitters, press the CH key:
Once to show transmitter 2
Twice to show transmitter 3
Three times to return to transmitter 1
Note: The transmitter number will only be displayed if there is more than one transmitter detected .
3. To reset the minimum and maximum temperature data and the times at which they were recorded, press the
OUT key continuously for about 3 seconds. This will reset all minimum and maximum data recorded to the
current time, date and temperature. The min/max temperatures recorded are of current time and they remain
unaffected by the time zone setting.
Maximum display
Outdoor transmission
signal