Skoda 5J0 054 907 Manual Del Usuario página 12

- 1 -
- Connect all conductors as per the figure.
- 3, 4 -
- Attach the LED (B) onto the car windscreen.
- By means of Velcro fasteners (L), glue the control unit (C) on the even surface behind the
GB
light switch. Place the control unit so that the unit terminal boards aim towards the
engine compartment.
In order to take the following wires out of their terminal boards, use tools from the set of
punchers.
- Signal "+15" - orange wire
- connect to the black/yellow wire of the terminal board A 44.
- Indicators - blue/green wire
- connect to the white/green wire of the terminal board A 28.
- Indicators - blue wire
- connect through the connecting tube (K) to the black/white wire of the terminal board
B 14.
- Signal "30" (Fig. 5) - red wire
- Slide into the free space in the fuse panel into the " + " position (depends on the equipment
of the vehicle).
- Slide the fuse 7.5A (D) in.
- Signal "31" - black wire
- connect to the brown wire of the light switch terminal board T17a (PIN 10).
- Central locking system - yellow/blue wire
- connect to the yellow/blue wire of the terminal board A 24.
Connect all fitted terminal blocks. Connect the white terminal board of the remote control
electric installation harness into the control unit (C).
Tighten the remote control electric wiring harnesses on suitable places, using
tightening tapes (not icluded in the delivery). Make sure the harness behind the
steering wheel rod is fastened in such manner to rise above the pedal system. Fasten
the harnesses to avoid their damage and occurrence of any disturbing noises during
the drive.