Power supply installation must be equipped with a residual current device (RCD)
having a residual operating current of ΔIn not exceeding 30mA. The manufacturer and
guarantor are exempt from any liability for damage to people or things, resulting from the
power supply of the device without relevant switch.
The presence of people or animals in the water where the pump is
working is not allowed.
In the event of damage of power supply cable insulation or the float cable
insulation it is not allowed to use the pump. In such a situation the guarantor
should be consulted for replacement of the cable. Mechanical damage is not subject to
guarantee free repairs. The use of the pump with damaged cable insulation at best will
lead to flooding of engine with water, while in the worst case scenario, it may result in an
electric shock.
If the pump works at a large distance from buildings and power supply is provided
with the use of an extension cord whose length is greater than 20 m, one should
unconditionally check voltage at the end of the extension cord before starting the
pump. One
should remember that with the increasing cable length power supply voltage at its
end decreases.
Pumps cannot be used at voltage drop below 210 V. The use of the pump under
such conditions will lead to overload of the motor and to its breakdown. In this case
repair will be possible only upon payment.
MAINTENANCE:
Disconnect power supply of the pump before
maintenance activities.
In case when the impeller of the pump is blocked with impurities, servicing activities
performed by the user should include cleaning of the impeller chamber. After each use,
the pump should be taken out of the tank and rinsed with clean water.
STORAGE:
Cleaned pump should be stored in a dry room.
One should ensure that the pump is not set on a power supply cable. At
quite considerable weight of the pump and a long period of storage cable
insulation can
be damaged.
UTILIZATION OF THE MACHINE:
Do not dispose of worn-out units through the household garbage!
The appliance, its packaging and accessories are all produced from recyclable
materials and must be disposed of accordingly.
11
performing any